CNC Simulator
X:
Y:
Z:
Time:
Pixels per inch:
Time step:
Speed factor:
Blitz mode:
Offset X:
Offset Y:
Enter CNC code here:
START MM 01 // Use millimeters, program ID 01 TD= 3.175 // Tool diameter: 1/8 in = 3.175 mm FR XY =03.7 // Divided the suggested feedrate by two, because tool was flexing. FR Z =01.2 // Feedrate based on 1 cutting edge, instead of 4, then slightly reduced. SETUP >zcxyu // Allow user to position tool above 1st hole. REPEAT 02 // Second traverse gets the edges better GOfX 0.000 // Go to 1st hole GOfY 0.000 // GO Z- 6.000 // Drill 1st hole Z>C // Raise tool CALL SUB 10 // Cut left side... ZERO AT // (Set origin to right hole) X 47.000 // * Change depending on connector * Y 0.000 // CALL SUB 11 // ...Cut right side... ZERO AT // (Reset origin to left hole) X- 47.000 // * Change depending on connector * Y 0.000 // GO X 6.920 // ...And return to Point 1. Y 3.410 // Z>C // Raise tool GOfX 47.000 // Go to 2nd hole * Change depending on connector * Y 0.000 // GO Z -6.000 // Drill 2nd hole Z>C // Raise tool REPEAT END // END NEW PART // SUB 10 // Left Side (located on line 050) GO X 6.920 // Point 1 Y 3.410 // GO Z- 9.000 // Insert tool ARC // Point 2 XC= 6.920 // YC= 1.500 // a= 101.470 // GO X 5.740 // Point 3 Y- 2.280 // ARC // Point 4 XC= 7.120 // YC=- 2.000 // a= 79.530 // SUB RETURN // SUB 11 // Right Side (located on line 100) GO X- 7.120 // Point 5 Y- 3.410 // ARC // Point 6 XC=- 7.120 // YC=- 2.000 // a= 79.530 // GO X- 5.050 // Point 7 Y 1.120 // ARC // Point 8 XC=- 6.920 // YC= 1.500 // a= 101.470 // SUB RETURN //
Output: